mlittle wrote:
110v input hot to center of q15 connection good, metered.
Top pin to neutral good, metered ( pin towards the top of the board) Is this checked with voltage or just continuity?
Lower Pin to out hot #16 terminal connection good ( pin to bottom of board) Is this checked with voltage or just continuity?
Being very careful what is the voltage on the lower pin? I am not presently at a location I can lay my hands on a board. I did have some issues with my kits in the past. Just need to try to determine the bad item, whether it is a joint or a component. There is a troubleshooting guide on the LOR website. I found the information very helpful.
